Acerca de
Installation
Note: where the Superboot is supplied with butyl ring on the underside, silicone is not required
Ensure roof surface is clean and free of dust rust and any oily substance.
If necessary cut to suit pipe diameter ensuring pipe is a tight fit.
Install Superboot over pipe and press firmly into shape of roof. Where butyl ring is not pre-fitted to the underside of the boot run a thick bead of silicone around the ripple track.
Using approved roofing screws, press the Superboot flange firmly into roof profile and screw down every 40mm. Clean up any excess silicone where applied.
1: When installing a Superboot ensure the area where the boot will be fixed in clean from any debris, rust, oily or greasy substance.
2: Trim boot opening to ensure a tight fit over the pipe to be flashed.
3: Place the boot over the pipe and press firmly into the profile of the roof with the protective butyl backing paper still in place.
4: Remove the boot from the pipe and remove backing paper ensuring butyl does not contact any contaminated surfaces prior to fitting.
5: After removing backing paper press boot firmly into roof profile.
Note: (in cold damp conditions, ensure roof is dry and that the butyl bonds, add a small bead of silicone between the butyl ring and outer edge of the underside of the boot if in doubt)
6: Press boot firmly back into roof profile and screw with approved metal class screws every 40mm
7: Clean any swarf from roof area
(Note Where a butyl ring has not been pre-fitted to the underside of the boot run a thick bead of approved roofing silicone in the ripple track on the underside of the flange.
RETROFIT
When using as a retrofit where the Superboot needs to wrap around the pipe, cut the Superboot down the middle of the retrofit rib.
Wrap the Superboot around the pipe ensuring a tight fit to the pipe
Silicone the ripple flange on the underside and fix at 40mm centres as above
Silicone both faces of the retrofit rib and slide the Superboot retro clip over the retrofit rib
Crimp the retro clip firmly into place ensuring both surfaces at tightly sealed